Field or control Description
Test Connection Tap to test the connection. If the connection test is successful, then OK is displayed. If the test is
unsuccessful, then No Response is displayed.
LAN Reset Tap to display the LAN Reset configuration menu (Utility > I/O menu) on page
195.
Apply Changes Apply changes made on this panel to the instrument.
Note: No changes are made to instrument settings until you tap the Apply Changes button.
USB Device Port fields and controls
Use the USB Device Port panel to enable or disable USB ports. Use USB ports to connect a USB memory device, keyboard, or for direct
PC control of the oscilloscope using USBTMC protocol.
Field or control Description
USB Device Port Tap to toggle all USB device ports On or Off.
USBTMC Configuration Displays the USBTMC configuration information.
Socket Server panel fields or controls
Use the following socket server settings to set up and use a socket server between your oscilloscope and a remote terminal or computer
.
Field or control Description
Socket Server Tap to toggle the socket server On or Off.
Protocol Tap to select a protocol, either None or T
erminal.
A communication session run by a user at a keyboard typically uses a terminal protocol. An automated
session might handle its own communications without such protocol from the oscilloscope.
Port Enter the port number using the multipurpose knob or virtual keypad.
AUX Out panel fields and controls
Use the following settings to select the signal that is output on the rear-panel AUX Out signal connector
.
Field or control Description
AUX Out Signal Sets the trigger output On or Off to send the signal to the AUX Out connector
.
Polarity Tap to select the polarity of the trigger signal (positive or negative pulse per trigger event). The polarity
control is present only for the Trigger output.
VNC Server panel fields and controls
Use the following VNC Server settings to set up a VNC server and password to access your oscilloscope remotely
.
Field or control Description
VNC Server Tap to toggle the VNC Server On or Off.
Password Double-tap the password fields to enter the password using virtual keyboard and tap Submit.
Remove Password Tap to remove the password for VNC Server. The instrument displays a popup message that confirms
the password is removed.
Menus and dialog boxes
194
To Next Page
Loading...
