Field or control Description
Mark On Sets the type of information for which to search and mark on the bus waveform acquisition.
Start of Frame sets a search mark at each occurrence of a CAN frame start.
T
ype of Frame sets a search mark at each occurrence of the frame type as set in the Frame Type
field.
Identifier sets a search mark at each occurrence of a CAN identifier frame as set in the Direction,
Identifier Format, and Identifier fields. Not available when the bus badge Decode Format is set to
Symbolic.
Data sets a search mark at the occurrence of the specified data fields (Data Bytes, Data Offset, Mark
When, and Data). Not available when the bus badge Decode Format is set to Symbolic.
Id & Data sets a search mark at each occurrence of the specified Id and data fields. Not available
when the bus badge Decode Format is set to Symbolic.
End of Frame sets a search mark at each occurrence of a CAN frame end.
Error sets a search mark at each occurrence of the specified error condition (Missing Ack, Bit
Stuffing, FD Form Error, or Any Error).
Frame Type Sets the frame type for which to search and mark on the bus waveform (Data Frame, Remote Frame,
Error Frame, Overload Frame).
Available only when Mark On is Type of Frame.
Direction Sets the Identifier's transfer direction (Read, Write, or Either) for which to search.
Available only when Mark On is Identifier.
Identifier Format Sets the CAN identifier format bit length for which to search (Standard 11-bit, or Extended 29-bit for
CAN 2.0B).
Available only when Mark On is Identifier or ID & Data.
Identifier Sets the identifier pattern for which to search. The number of bits shown depends on the Identifier
Format setting.
Tap the Binary or Hex field and use the A and B knobs to select and change the values. Or double-tap
on the field and use the virtual keypad to enter values.
Available only when Mark On is Identifier or ID & Data.
Data Bytes Sets the number of data bytes for which to search (one to eight bytes). Use the A knob to change the
value.
Available only when Mark On is Data or ID & Data.
Data Offset Sets the data offset value. Use the A knob to change the value.
Available only when Mark On is Data or ID & Data.
Mark When Sets the mark when condition (mark the waveform when the waveform is is, ≠, <, >, ≤, or ≥ the data
conditions).
Available only when Mark On is Data or ID & Data.
Table continued…
Menus and dialog boxes
144
To Next Page
Loading...
