Field or control Description
Symbolic Sets the search for each occurrence of a specified message or signal condition as defined by an
installed .dbc symbol definition file.
This search setting is available when the Decode Format is set to Symbolic from CAN bus
configuration menu.
Start of Frame Sets the search for each occurrence of a CAN frame start.
End of Frame Sets the search for each occurrence of a CAN frame end.
Type of Frame Sets the frame type for which to search.
This search setting is available when Decode Format is set to Symbolic from CAN bus configuration
menu.
Configure Opens the CAN DBC Symbolic Configuration menu, which sets the CAN bus search parameters
based on the message and signal labeling derived from an installed .dbc symbol definition file. See
CAN serial bus search configuration menu (when using a .dbc symbol definition file) on page
145.
Message, Signal, and Value
fields
These fields display the actual search data values for the Message, Signal, and Value fields as set
in the CAN DBC Symbolic Configuration menu. These fields are shown for reference and are not
editable.
Data Sets the data for which to search.
Available when CAN Standard is in CAN XL, CAN 2.0 + FD (ISO) + XL, CAN 2.0, or CAN FD (ISO)
except when Decode Format is set to Symbolic from CAN bus configuration menu.
ID & Data Sets the ID & Data type for which to search.
Available when CAN Standard is in CAN 2.0 + FD (ISO) + XL, CAN 2.0, or CAN FD (ISO) except
when Decode Format is set to Symbolic from CAN bus configuration menu.
Identifier Sets the identifier pattern on which to search.
Available when CAN Standard is in CAN 2.0 + FD (ISO) + XL, CAN 2.0, or CAN FD (ISO) except
when Decode Format is set to Symbolic from CAN bus configuration menu.
FD Bits Sets a search mark at each occurrence of the specified BRS Bit (Bit Rate Switch) and ESI Bit (Error
State Indicator) states.
Available only when CAN Standard is in CAN FD (ISO) except when Decode Format is set to
Symbolic from CAN bus configuration menu.
XL Bits Sets the FD bits value on which to search.
Available when CAN Standard is in CAN XL or CAN 2.0 + FD (ISO) + XL from CAN bus configuration
menu.
BRS Bits Sets the BRS (Bit Rate Switch) bit state for which to search and mark at each occurrence on the bus
waveform.
Available only when Mark On is FD Bits.
ESI Bits Sets the ESI (Error State Indicator) bit state for which to search and mark at each occurrence on the
bus waveform.
Available only when Mark On is FD Bits.
Table continued…
Menus and dialog boxes
146
To Next Page
Loading...
