CAN serial bus menu fields and controls
Field or control Description
Display Turns on or off displaying the bus on the Waveform view.
Label Enter a label for the bus. Default standard label is the selected bus type.
T
o enter label text, double-tap the field and enter label using the virtual keyboard, or tap the field and
enter text from an attached keyboard.
Position Sets the vertical position of the bus waveform. Default standard position is vertically centered in a slice
(in Stacked mode), or center screen in Overlay mode. The unit of position is screen divisions.
Set to 0 Sets the vertical position to 0 divisions (centered vertically in a slice or on the screen).
Results Table Sets the results table as On or Off to see the active measurements, bus decode activity, and search
results in a spreadsheet format. Default is off.
Bus Type Set to CAN to set up and display a CAN bus waveform.
Signal Type Sets the CAN signal type to decode.
Available signal types are Diff, CAN_H, CAN_L, Rx, and Tx.
Default standard is CAN_H.
CAN Standard Sets the CAN signal standard to decode.
Available CAN standards are CAN 2.0, CAN FD (ISO), CAN FD (non-ISO), CAN 2.0 + FD (ISO) + XL,
and CAN XL.
Default standard is CAN 2.0.
Source Select the signal source from listed analog and digital channels.
Threshold Sets the high/low logic transition level.
Sample Point Sets the sample point from 5% to 95% of the position within the bit period or the unit interval.
Bit Rate Sets the bit rate of your CAN bus serial data.
To enter a custom bit rate, select Custom and enter the custom bit rate in the Custom Rate input box.
This control is available when CAN Standard is set to CAN 2.0.
SD Bit Rate Sets the SD bit rate of your CAN FD serial bus data.
To enter a custom bit rate, select Custom and enter the custom bit rate in the Custom Rate input box.
This control is available when CAN Standard is set to CAN FD (ISO), CAN 2.0 + FD (ISO) + XL, or
CAN FD (non-ISO).
FD Bit Rate Sets the FD bit rate of your CAN FD serial bus data.
To enter a custom bit rate, select Custom and enter the custom bit rate in the Custom Rate input box.
This control is available when CAN Standard is set to CAN FD (ISO), CAN 2.0 + FD (ISO) + XL, or
CAN FD (non-ISO).
Nominal Bit Rate Sets the data rate for Arbitration mode.
To enter a custom bit rate, select Custom and enter the custom bit rate in the Custom Rate input box.
Ranges from 10 Kbps to 1 Mbps.
This control is available when CAN Standard is set to CAN XL.
Table continued…
Menus and dialog boxes
134
To Next Page
Loading...
