Field or control Description
Symmetry Sets the symmetry of the ramp using the keypad or multipurpose knob.
A
vailable when the Waveform Type is Ramp.
Width Sets the width of the pulse using the keypad or multipurpose knob.
Available when the Waveform Type is Pulse.
Duty Cycle Sets the duty cycle of the square wave using the keypad or multipurpose knob.
Available when the Waveform Type is Square.
Frequency Sets the frequency of the waveform using the keypad or multipurpose knob. The frequency range is
0.1 Hz to 50 MHz, in increments of 0.1 Hz.
Period Sets the period of the waveform using the keypad or multipurpose knob.
Amplitude Sets the amplitude of the waveform using the keypad or multipurpose knob
Offset Sets the offset of the waveform using the keypad or multipurpose knob.
High Level Sets the High signal amplitude of the waveform using the keypad or multipurpose knob
Low Level Sets the low signal amplitude of the waveform using the keypad or multipurpose knob.
Load Impedance Tap to select either 50 Ω or High Z (1 MΩ) output load impedance.
Add Noise Tap the check box to toggle noise on and off. Set the amount of noise to add to the output signal using
the keypad or the multipurpose controls.
AFG output amplitude ranges by impedance (peak to peak)
Waveform 50 Ω High Z
Sine 10 mV to 2.5 V 20 mV to 5 V
Square 10 mV to 2.5 V 20 mV to 5 V
Pulse 10 mV to 2.5 V 20 mV to 5 V
Ramp 10 mV to 2.5 V 20 mV to 5 V
DC 0 V to ±1.25 V 0 V to ±2.5 V
Noise 10 mV to 2.5 V 20 mV to 5 V
Sine(x)/x 10 mV to 1.5 V 20 mV to 3 V
Gaussian 10 mV to 1.25 V 20 mV to 2.5 V
Lorentz 10 mV to 1.2 V 20 mV to 2.4 V
Exponential Rise 10 mV to 1.25 V 20 mV to 2.5 V
Exponential Decay 10 mV to 1.25 V 20 mV to 2.5 V
Haversine 10 mV to 1.25 V 20 mV to 2.5 V
Cardiac 10 mV to 2.5 V 20 mV to 5 V
Arbitrary 10 mV to 2.5 V 20 mV to 5 V
Menus and dialog boxes
164
To Next Page
Loading...
