Field or control Description
Horizontal Center Sets the segment horizontal center, as time units, as the point halfway between the leftmost vertex and
rightmost vertex.
Flip Horizontal Flips the segment horizontally around its Horizontal Center value.
Rotate Rotates the segment in units of degrees, from 0° to 360°.
The rotation is an absolute angle measurement referenced from 0°, where 0° is the position of the
segment when it was first created. For example, if you rotate the segment 40°, and then rotate it again
with 20°, the resulting segment rotation is 20°.
The segment height and width are relative to the current segment orientation, and automatically
change places as needed when the segment is rotated.
Tolerance Type Sets the tolerance type as Screen or Absolute. Default type is screen.
Vertical Tolerance Tap the Vertical Tolerance field and enter the tolerance value as divisions of the current channel
settings (volts, amps, and so on). Or double-tap on the field and use the A knob to change the value.
Horizontal Tolerance Tap the Horizontal Tolerance field and enter the tolerance value as divisions of the current channel
settings (volts, amps, and so on). Or double-tap on the field and use the A knob to change the value.
Update Mask Now Updates the mask as per the configured tolerance values.
Edit Vertices panel fields and controls
Field or control Description
Define Segment A table that lists the X (time) and Y (amplitude) values for each vertex (point) of the segment. Use the
scroll bar to show points if there are more than nine points in the segment.
Selecting a row in the table highlights the associated vertex on the segment.
Use the Multipurpose knobs to change the value of the X or Y settings, or double-tap a setting and
enter the value directly.
Table continued…
Menus and dialog boxes
172
To Next Page
Loading...
