c. T
ap a plus symbol to add a new vertex at that location. The segment is redrawn to show the new vertex. You can continue to add
vertices; there is no limit to the number of vertices in a segment.
Note: Y
ou cannot move vertices while in add/delete vertex mode.
d. T
o exit add/remove vertex mode, tap outside the mask segment. The instrument returns to normal operation.
5. To move vertices in a mask segment:
a. Tap the segment three times to enable move vertex mode. The move vertex mode draws crosshairs on all vertices of the segment.
b. T
ouch and drag a vertex to move it to a new position.
c. To exit move vertex mode, tap outside the mask segment. The instrument returns to normal operation.
6. To rotate a mask segment:
a. Tap four times in the segment to enable rotate segment mode.
b. T
ouch and drag the dot in the segment to rotate it.
Note: Once you are touching and dragging the rotate dot, you can move your finger outside of the segment to get finer
control over the rotation increments.
Mask testing waveforms
2 Series MSO MSO24 and MSO22 91
To Next Page
Loading...
