Tescom TC-3000C - Page 106

5.3 Reference Guide using RS-232C commands
106
READ:SYS:DUT:BAUDRATE?
Description
This command reads baud rate depending on the type of HCI transport layer of a DUT.
CONF:SYS:DUT:BAUDRATE <Value>
Description
This command writes baud rate depending on the type of HCI transport layer of a DUT. It is available for
UART or BCSP.
Value
baud rate : 2400, 4800, 9600, 19200, 38400, 57600, 115200
READ:SYS:DUT:TEST_MODE?
Description
This command reads the test mode of the DUT.
CONF:SYS:DUT:TEST_MODE <Value>
Description
This command writes the test mode of the DUT. The test mode supports testing of the Bluetooth transmitter
and receiver. It is intended mainly for certification/compliance testing of the radio and baseband layer and
may also be used for regulatory approval or acceptance on a HW or SW interface shall be allowed.
Value
test mode : LOOPBACK_TEST(default), TRANSMITTER_TEST, NULL_PKT_TEST
READ:SYS:DUT:POW_SET_TIME?
Description
This command reads interval of time when the tester must to wait after until the DUT will reach the new
power step in milliseconds.
CONF:SYS:DUT:POW_SET_TIME <Value>
Description
This command writes interval of time when the tester must to wait after until the DUT will reach the new
power step in milliseconds.
Value
power set time : 1 ~ 65535, 1000(default)
READ:SYS:RF:TX_POW?
Description
NOTE
If you want to enter test mode without LMP connection, you must set this value
to OFF. That is to say, if your test aim is just to measure RF test cases, set OFF.
NOTE
In general, test mode must be loopback or transmitter mode except for audio test.