Tescom TC-3000C - Page 36

3.2 Basic Operation Procedure
36
Caution
When TC-3000C is turned on, the instrument always recalls the settings from
the most recently saved register. But if the TC-3000C can’t find any DUT in
the preset HCI port while the TC-3000C is turned on, “HCI Port” of DUT
configuration is set to “None”..
7. Make sure the “DUT Type” of DUT configuration: Press Menu  Select
“Configuration” from the pop-up menu on the screen  M2 (DUT)  F2 (DUT
Type). Make sure the “DUT Type” of DUT configuration is correct.
8. Input the Path Loss: Press Menu  Select “Configuration” from the pop-up menu
on the screen
M2 (DUT)  F7 (Path Loss). Input the path loss value from the TC-3000C to the
DUT.
9. Select the Test mode (Transmitter, Loop back or Null Packet): Press Menu 
Select “Configuration” from the pop-up menu on the screen  M2 (DUT)  Press F8
three times for “More 4/4” menu  Press F2 and select a test mode from the drop
down menu.