3.6 Operation Procedure (EDR Measurement)
59
2. TX-BER (Bit Error Rate): To access TX-BER screen, press M2 soft key. The
purpose of this measurement is to test DUT’s PSK modulation quality. This test is not the
DUT’s RX sensitivity so output power of TC-3000C should be set enough high. This
screen shows the TX-BER measurements that are carried out by checking data in PSK
payload fields received from the DUT. This test is performed in Transmitter test mode
only.
Num. Of packet: specifies the number of packet
to measure
BER: Displays the TX-BER measure to
the sent bytes that are specified in
“Length” menu.
PER: Displays the TX-PER(Packet
Error Rate) measure
Test mode: Configures Bluetooth Test
Mode connection with DUT
To Next Page
Loading...
