3.10 Configuration of the TC-3000C
75
Defines the save-mode of Test Cases report file; [Append]
or [Overwrite]
Bluetooth Device Address of the tester’s Host Controller
Must be entered in little ending format (LSB in the right
side) in hexadecimal notation.
Lower Address Part (3 bytes) of BD_ADDR, from which
the Inquiry Access Code will be derived when the inquiry
procedure is performed; 9e8b33 is GIAC
Defines the amount of time between consecutive inquiry
scans, i.e., the time interval from the time when the Host
Controller starts its last inquiry scan to the time when it
begins the next inquiry scan.
Defines the amount of time for the duration of the inquiry
scan, and T winqscan must be less than or equal to the T
inqscan.
Defines the maximum amount of time specified before the
Inquiry is halted.
Defines the maximum number of responses from the
Inquiry before the Inquiry is halted; 0 means unlimited
number of responses
Defines the amount of time between consecutive page
scans, i.e., the time interval from the time when the Host
Controller starts its last page scan to the time when it
begins the next page scan.
Defines the amount of time for the duration of the page
scan, and T wpagescan must be less than or equal to the
T pagescan.
Defines the maximum time the local Link Manager will wait
for a Baseband page response from the remote device at
a locally initiated connection attempt.
If this time expires and the remote device has not
responded to the page at baseband level, the connection
attempt will be considered as failure.
Defines the type of PIN to be used
Defines the length of the PIN code (in bytes)
Defines the PIN code for the device to be connected; each
byte should be separated by a point. For example, if the
PIN Code is “1234”, type 31,32,33,34
Defines the timeout of L2CAP commands execution
Defines the timeout of RFCOMM commands execution
To Next Page
Loading...
