Thermo Scientific Micro-Tech 9101 - Page 11

Table of Contents
Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J v
Number of Weigh Idlers ............................................................ 2-30
Pivot-to-First-Idler Distance ...................................................... 2-30
Pivot-to-Test-Weight Height ..................................................... 2-30
Pivot-to-Test-Weight Length ..................................................... 2-30
Pivot-to-Carriage Height ............................................................ 2-30
Roller-to-Stringer Height ........................................................... 2-30
Number of Load Cells ................................................................ 2-30
Idler Spacing .............................................................................. 2-30
Conveyor Angle ......................................................................... 2-31
Load Cell Capacity, Sensitivity, and Resistance ....................... 2-31
Setting the Speed Input .............................................................. 2-31
Establish Test Duration ................................................................. 2-32
The Next Step ............................................................................... 2-36
Operation .................................................................................. 3-1
Overview ............................................................................................ 3-1
Using the Console .............................................................................. 3-1
Display Screen ................................................................................ 3-1
Keypad ............................................................................................ 3-1
Soft Key Buttons ............................................................................. 3-2
Status LEDs .................................................................................... 3-2
Running the Micro-Tech .................................................................... 3-2
Run Screen ...................................................................................... 3-3
Viewing the Totals .......................................................................... 3-3
Resetting the Totals......................................................................... 3-4
Resetting the Reset and Operator Totals ...................................... 3-4
Calibrating the Micro-Tech ................................................................ 3-5
Doing a Zero Calibration ................................................................ 3-5
Doing an R-Cal Span Calibration ................................................... 3-7
Maintenance and Troubleshooting ........................................ 4-1
Critical Checkpoints........................................................................... 4-1
Frequently Asked Questions .............................................................. 4-1
Load-Cell Problems ........................................................................... 4-3
Overview ......................................................................................... 4-3
Four-Wire Load-Cell, No Sense Leads ........................................... 4-4
Four Wire Load-Cell, With Sense Leads ........................................ 4-5
Six-Wire Load-Cell With Sense Leads ........................................... 4-6
Analog Input/Output Problems .......................................................... 4-7
Overview ......................................................................................... 4-8
Procedure ........................................................................................ 4-8
Opto22 Problems ............................................................................. 4-12
Navigating to the Digital Output Test Screen ............................... 4-12
Test Procedure for the Output Module ......................................... 4-13
Test Procedure for the Input Module ............................................ 4-14
Chapter 3
Chapter 4