Toshiba e-STUDIO3510c - Scanning the next originals during copying (Auto job start)

2 HOW TO MAKE COPIES
76 Making Copies
5
Place the next original, and press the [START] button.
y Data scanning of this original starts.
y The next original will also be scanned in the same manner when you press the [YES]
button on the touch panel and then press the [START] button on the control panel.
y Repeat the above procedure until the scanning of the last page of the original fin-
ishes.
6
When scanning of all pages has finished, press the [FINISHED] but-
ton on the touch panel.
Copying starts. The paper exits with its copied side down.
y When the drawer runs out of paper during copying, the corresponding drawer on the
touch panel and the [JOB STATUS] button on the control panel blink. Add paper to
this drawer or select another one with the same paper size.
y Be careful because the paper exit area and paper just after exiting are hot.