6 Mapping and Guidance
102 FM-750 Display User Guide
3. If you want to map the adaptive curve:
– Automatically; select On.
– Manually; select Off.
To map an adaptive curve with automatic turn detection:
1. Drive to the start point of the curve.
2. Tap and then drive the initial curve.
3. At the end of the first curve, perform a U-turn. The system detects the turn and
generates the next swath.
To map an adaptive curve manually:
1. Drive to the start point of the curve.
2. Tap and then drive the initial curve.
3. At the end of the first curve, tap . The system generates the next swath.
4. Continue to drive the swaths, setting the B point at the end of each one.
Using the adaptive curve pattern for row-finding
1. Set Auto U-Turn Detection to Off.
2. Create a guidance line based on the adaptive curve pattern.
3. Set the B point at the end of each row.
4. Turn the vehicle toward the next swath. When the vehicle is halfway through
the turn, guidance along the next swath appears.
Pivot
Use the pivot pattern on fields that use center-pivot
irrigation. With this pattern you can drive concentric
circles around the center-pivot.
To map a pivot:
Note – Always set the master line near the outer edge of the
field.
1. Drive to the start point of the pivot.
2. Position one wheel of the vehicle in a pivot wheel rut, with the rear of the vehicle
to the pivot arm. If the field is not a full circle pivot, face the rear of the vehicle
to the edge of the field.
3. Tap and then drive around the field. Keep the vehicle in the rut. The
display will generate guidance swaths.
4. Turn left or right for the next swath. As you move toward the next swath, it
appears on the screen and turns orange to show that it is selected.
To Next Page
Loading...
