Safety
6 FM-750 Display User Guide
C
WARNING – When the implement is down and the master switch is in the On position,
the machine is fully operational. Take all necessary precautions to ensure user safety.
Failure to do so could result in injury or death.
C
WARNING – The display contains a single-use Lithium-sulfide LiSO2 battery. Do not
expose the battery to temperatures greater than 71 °C (160 °F) as the battery may
explode.
C
WARNING – MOVING PARTS DURING THIS TEST! Please stay clear of the implement.
Ensure the implement is raised, the transmission is in PARK and the emergency brake is
applied before continuing.
Working with anhydrous ammonia
• Contact your NH3 supplier to review all safety requirements associated with anhydrous
ammonia (NH3).
• Always wear correct personal protective equipment. This includes, but is not limited to:
– Goggles or face shield
–Protective suit and gloves
–Respirator
• Do not allow anyone to operate the system without proper instruction and training.
• Stand up-wind when working around NH3 and related equipment.
• Always keep NH3 equipment away from buildings, livestock, and other people.
• Never work on NH3 equipment in confined spaces.
• Before you attempt to transport the implement, discharge the system of all NH3 and
completely shut down the system. See Discharging the system, page 7.
• If symptoms of illness occur during or shortly after use of NH3 products, seek immediate
medical attention.
• Keep a source of clean water (at least five gallons) readily available. In case of exposure, flush
exposed skin or eyes immediately with large quantities of water and seek immediate medical
attention.
• NH3 can be harmful to the environment if not used correctly. Follow all local, state, and federal
regulations regarding proper handling of this chemical.
20.1 Servicing the equipment
1. Remove the system from operation before performing any maintenance.
2. Thoroughly bleed all system lines and disconnect the nurse tank hose. See
Discharging the system, page 7.
To Next Page
Loading...
