EasyManua.ls Logo

Trimble FM-750 - Installing the antenna

Default Icon
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FM-750 Display User Guide 21
Installing the Display and Antenna 2
Installing the antenna
Note – To minimize any interference to the GPS signal, make sure that the GPS antenna is
at least 1 m (3 ft) from any other antenna (including a radio antenna). You may experience
interference if you operate the vehicle within 100 m (300 ft) of any power line, radar dish,
or cell phone tower.
Note – The AG25 antenna has integrated magnets for easy installation. To attach the
antenna to a non-metal surface, you must use the mounting plate.
To install the AG25 antenna:
1. Find the mounting location for the antenna at the front of the vehicle roof,
centered from left to right.
2. On the mounting plate, remove the protective covers from the adhesive strips.
3. Attach the mounting plate to the vehicle roof with the adhesive strips. Ensure
that the mounting plate is centered along the vehicle roof.
4. Connect the antenna cable to the antenna.
5. Place the antenna directly on the mounting plate. The three magnets embedded
in the bottom of the antenna will hold it in place.
6. Route the other end of the antenna cable into the cab.

Table of Contents

Other manuals for Trimble FM-750

Related product manuals