Trimble FM-750 - Safety; Warnings

FM-750 Display User Guide 5
Safety
Always follow the instructions that accompany a Warning or Caution. The information
they provide is intended to minimize the risk of personal injury and/or damage to
property. In particular, observe safety instructions that are presented in the following
format:
C
WARNING – This alert warns of a potential hazard which, if not avoided, can cause severe
injury.
C
CAUTION – This alert warns of a hazard or unsafe practice which, if not avoided, can
cause injury or damage.
Note – An absence of specific alerts does not mean that there are no safety risks involved.
Warnings
C
WARNING – Anhydrous ammonia (NH3) can cause severe burning, blindness, or death.
Before you begin to operate or service equipment that contains NH3, carefully read and
follow all safety instructions in Working with anhydrous ammonia, page 6.
C
WARNING – Incorrect adjustment of the Manual Override Sensitivity calibration setting
could cause this critical safety feature to fail, resulting in personal injury or damage to the
vehicle. Any adjustment to this setting should only be made by an experienced user.
C
WARNING – During the Deadzone calibration, the system moves the vehicle’s steering
wheels. To avoid injury, be prepared for sudden vehicle movement.
C
WARNING – When you tap the liquid flow calibration Start button, the machine will
become operational. Take all necessary precautions to ensure user safety. Failure to do so
may result in serious injury or death.
C
WARNING – When you tap the control valve calibration Start button, the machine will
become operational. Take all necessary precautions to ensure user safety. Failure to do so
may result in serious injury or death.
C
WARNING – When you tap the fill disk Start button, the machine will become
operational. Take all necessary precautions to ensure user safety. Failure to do so may
result in serious injury or death.