5 Implement Application Controller
82 FM-750 Display User Guide
Amazone
Setup
1. Once you select Amazone as your controller, the following screen appears on
the display:
Note – Do not configure the display to output NMEA messages on the same port that your
controller is connected to.
2. On the Amazone controller, go to the Settings menu.
3. Change Remote to Enable.
For more information on setting up the Amazone controller, refer to the Amazone
instruction manual.
Advanced
Use the Advanced option in the Implement screen to configure the following:
• Boom Setup
• Swath Control
• Rate Control
• Target Rate
• Turn Off Rate on Overlap
• Rate Snapping
Boom Setup
Note – The boom setup on the FM-750 display must match the setup on the Amazone
controller. If the boom setup differs between the display and the Amazone controller, a
warning message appears on the display.
To Next Page
Loading...
