FM-750 Display User Guide 85
Implement Application Controller 5
LH 5000
Setup
1. Once you select the LH5000 as your controller, the following screen appears on
the display:
2. On the FM-750 display, make sure that Output Port matches the port on the
display that the controller is connected to (COM or AUX).
3. Do not configure the display to output NMEA messages on the same port that
your controller is connected to.
For more information on configuring the LH 5000 controller, refer to the LH 5000
instruction manual.
Advanced
Use the Advanced option in the Implement screen to configure the following:
• Boom Setup
• Swath Control
• Rate Control
• Target Rate
• Turn Off Rate on Overlap
• Rate Snapping
Boom Setup
Note – The boom setup on the FM-750 display must match the setup on the LH 5000
controller. If the boom setup differs between the display and the LH 5000 controller, a
warning message appears on the display.
To Next Page
Loading...
