5 Implement Application Controller
72 FM-750 Display User Guide
Use this option to view and adjust the following settings:
Swath Control
Use this option to view and adjust the following settings:
Rate control
Use this option to view and adjust the following settings:
Note – When sending a target rate to the HARDI 5500 controller that is higher than 99.9,
the display rounds to the nearest whole number. For example, 0-99.9 is not rounded. 101.4
is rounded to 101.
Off When Stopped
You can use this option to control whether the system allows the vehicle to continue
operating when it is not moving.
If the vehicle is a clutch-operated planter, select No so you can continue planting even
when stopped.
Setting ... Notes ...
Implement width Enter a width between 1' 00" - 328' 01" (0.30 - 99.99 m).
Fence Nozzles Enter the locations of any fence nozzles.
Number of sections Enter a number between 1 - 10.
Setting ... Notes ...
Boom control Enter a width between 1' 00" - 328' 01" (0.30 - 99.99 m).
Coverage switching overlap Control the amount of boom switching overlap allowed before the
section will be switched by the system.
Enter a value between 1 - 99%.
Boundary switching overlap Control the amount of overlap on a boundary before the boom section
is switched off.
Enter a value between 1 - 99%.
On/Off valve latency Tune the section switching to allow for hardware delays.
Enter a time between 0.0 - 10.0 seconds.
Intentional overlap Set a distance to be overlapped when moving to an unsprayed area or
out of a sprayed area.
Enter a distance between 0' 00" - 32' 10" (0.00 - 10.00 m).
Setting ... Notes ...
On Application rates are sent from a prescription loaded in the display or the target rate
manually configured on the display.
Off The target rate must be set on the HARDI controller. The FM-750 display does not
send target rates to the controller. This is the default setting.
To Next Page
Loading...
