Turin Networks Adit 3000 Series and Multi-Service Router (MSR) Card none - Page 444

23-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port FXS Mode
signal
Use the Voice Port FXS signal command to set the signaling protocol.
Syntax: (config-vport-fxs-{n})# signal {ground-start|loop-start}
Example: (config-vport-fxs-1)# signal ground-start
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field Definition
ground-start Sets the line to Ground Start signaling
loop-start Sets the line to Loop Start signaling