WAGNER TITANUS - Incorporating Reset and Isolating Button Board

TITANUS MICRO·SENS
®
Installation
MS_A_05-en-e Data: 01/09 5 – 13
5.6 Incorporating the reset and isolating
button board
If a reset or isolating button is needed, the plate must be fitted into an
additional housing.
4
Fig. 5.12: Incorporating the reset and isolating board into the TITANUS MICRO·SENS
®
ad-
ditional housing
Fitting Proceed as follows to incorporate the reset and isolating button board:
1
Using a screwdriver, loosen the four screws on the additional
housing cover.
2
Push the spacer blocks into the installation board
(for fixing points
see Fig. 5.8) on the additional housing. The reset and isolating but-
ton board is then engaged with the spacer blocks using the holes
provided
.
3
Feed the wires through as per the following switching plan.
4
Fit the cover again, using a screwdriver to fit the four screws on the
device cover firmly
.