Weber Alpha HSM - Page 65

Chapter 7 Settings and commissioning 40058725 BTA Alpha HSM
Version: 12.19.17 Page 65 of 112 GB
Step
Approach
7
Navigate to the menu page "IP Address" and assign your IP address to the
labelers.
Fig. 7-17: IP address
8
Only with the master labeler:
Navigate to the menu page "Link IP_Address" and enter the IP address of
the slave labeler.
Fig. 7-18: IP-address link
9
Switch both labels off at the power switch and on again approx. 15 seconds
later.
During a label roll change, the systems must remain switched on to ensure the data
transfer.
Instruction
This is how you set up the master system at the end of the roll.
Step
Approach
Risk of injury! Carry out the roll change while observing all safety measures.
1
Change the label roll (see Chapter “Loading the label material“ as a page
54).
2
Acknowledge possible error messages with the [Stop] button on the HMI
display.
3
Alternating operation
The master system is now in standby. In case of a failure of the slave sys-
tem (e.g. end of roll) the master system is switched to automatically.
ZeroDownTime
Press the [START] button on the HMI display.
It is immediately switched to the master system. The slave system will be in
standby again.
IP address
192,168. 8. 234
IP-Addr IP-Mask X
255,255,255. 0
IP address link
192,168. 8. 206
IP-Addr X