7.3 Program Table Operation
7.3.6 SigmaWin+ Procedures
7-28
3.
Click the OK Button.
This concludes the setting procedure.
AREA1 and AREA2
Set the areas for the program steps. AREA1 and AREA2 are the tow positions that define one
area.
Select the cells to edit and enter the values directly.
The relationship between the setting of AREA1 and AREA2 and the specified area are shown
below.
If AREA1 is less than or equal to AREA2, the shaded area shown below is used.
If AREA1 is greater than AREA2, the shaded areas shown below are used.
EVENT
Specify the conditions to complete execution of the program steps.
1.
Double-click the cell to edit.
The Event Dialog Box will be displayed.
2.
Set the condition and the wait time.
Unit Setting Range Default Setting
Reference units 1 to 99,999,999 10
Unit Setting Range Default Setting
Reference units -99,999,999 to 99,999,999 0
To Next Page
Loading...
Need help?
General
