YASKAWA E-S Series - Page 265

11.1 List of Parameters
11.1.2 List of Parameters
11-15
11
Parameter List
PnBAA
2
/SEL3
(Program Step
Selection Input 3)
Signal Allocation
0000h to
00C3h
− 0080h
After
restart
Setup page 5-11
PnBAB
2
/SEL4
(Program Step
Selection Input 4)
Signal Allocation
0000h to
00C3h
− 0090h
After
restart
Setup page 5-11
Continued on next page.
Continued from previous page.
Parameter
No.
Size Name
Setting
Range
Setting
Unit
Default
Setting
When
Enabled
Classi-
fication
Reference
n.X Signal Usage Method
0
The /SEL3 (Program Step Selection Input) signal is active when the input signal is
ON (closed).
1
The /SEL3 (Program Step Selection Input) signal is active when the input signal is
OFF (open).
2 The /SEL3 (Program Step Selection Input) signal is always active.
3 The /SEL3 (Program Step Selection Input) signal is always inactive.
n.X Signal Terminal Number
Same as PnBA0 = n.X.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Signal Usage Method
0
The /SEL4 (Program Step Selection Input) signal is active when the input signal is
ON (closed).
1
The /SEL4 (Program Step Selection Input) signal is active when the input signal is
OFF (open).
2 The /SEL4 (Program Step Selection Input) signal is always active.
3 The /SEL4 (Program Step Selection Input) signal is always inactive.
n.X Signal Terminal Number
Same as PnBA0 = n.X.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)