11.2 Parameter Recording Table
11-33
* The enable timing depends on the digit that is changed. Refer to the following section for details.
11.1 List of Parameters on page 11-2
PnBD8 0002h
/ZONE2 (ZONE Output 2)
Signal Allocation
After restart
PnBD9 0002h
/ZONE3 (ZONE Output 3)
Signal Allocation
After restart
PnBDB 0002h
Reserved parameter
(Do not change.)
After restart
PnBE1 25
Pressing Torque for Press-
ing Homing
Immediately
PnBE2 250
Pressing Detection Time
for Pressing Homing
Immediately
PnBE3 250
Pressing Time for Pressing
Homing
Immediately
PnBE4 250
Pressing Operation Com-
pletion Wait Time
Immediately
Continued from previous page.
Parame-
ter No.
Default
Setting
Name
When
Enabled
To Next Page
Loading...
