Explanation
You can use a PC or workstation to connect to the WT500 over a network and access its
internal RAM disk and the USB memory connected to its USB ports.
The PC or workstation must have FTP client software to access the WT500.
Setting the User Name
• Set the user name that a user can enter to gain access to the WT500.
• You can enter up to 15 characters.
• The characters that you can use are: 0-9, A-Z, %, _, parentheses, and minus signs.
• If you set the user name to “anonymous,” a PC or workstation can access the WT500
without a password.
Setting the Password
• Set the password that that a user can enter to gain access to the WT500.
• You can enter up to 15 characters.
• The characters that you can use are: 0-9, A-Z, %, _, parentheses, and minus signs.
• If you set the user name to “anonymous,” a PC or workstation can access the WT500
without a password.
Setting the Timeout Value
If the WT500 is not accessed within a given period of time (specified by the timeout
value), it will disconnect from the network.
The timeout value can be set from 0 to 3600 s. The default value is 600 s.
Note
• The WT500 can only connect to one client at a time.
• The FTP server feature does not function when the WT500 is manipulating files (see chapter
10 for details).
• In the root directory of a PC or workstation that accesses the WT500, the internal RAM disk
appears as “[RAM0-0]”, and the USB memory appears as “[USB0-0]” or “[USB1-0].”
• Before using the FTP server feature, follow the procedures in section 11.3, “Configuring
TCP/IP Settings” to configure TCP/IP settings.
11.4 Accessing the WT500 from a PC or Workstation (FTP server feature)
To Next Page
Loading...
Need help?
General
