3-33
IM 760201-01E
Before You Start Measuring
3
2
1
4
5
6
7
8
9
10
11
12
13
14
App
Index
3.17 Displaying a List of Setup Parameters
Procedure
Displaying the Setup Parameter List
1.
Press SHIFT+SETUP (INPUT INFO). A list of input conditions (such as the wiring
units for each element, the measurement range, the scaling coefficient, the
synchronization source, and the input filter) appears.
Closing the Setup Parameter List
2.
Press SHIFT+SETUP (INPUT INFO) or ESC (when no menus are displayed). The
list of setup parameters closes.
Explanation
Setup Parameter List
The figure below is an example of a setup parameter list when the crest factor is set to 3.
Note
The list of input conditions shows the settings when measurement took place. If the
measurement range or some other setting is changed while the hold feature is on, the changes
will not be reflected in the list.
To Next Page
Loading...
