YOKOGAWA WT500 - 10.3 Saving Setup Parameters, Waveform Display Data, and Numeric Data

10-4
IM 760201-01E
10.3 Saving Setup Parameters, Waveform Display
Data, and Numeric Data
Procedure
1.
Press FILE to display the File menu.
Selecting the Type of Data That You Want to Save
2.
Use the cursor keys to select File Item.
3.
Press SET to display the data type selection box.
4.
Use the cursor keys to select a data type from Setup to Numeric.
5.
Press SET to confirm the selection.
If you select Setup or Wave, proceed to step 11 in “Executing or Canceling the Save
Operation” on page 10-6.
If you select Numeric, proceed to “Selecting What Numeric Data to Save” on page 10-5.