ABB ACS6080 - Figure 5-19 Tools Required to Fasten the Pressure Relief Vent to the Roof; Figure 5-20 Installation Example of Pressure Relief Vents

MECHANICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
112/266
Figure 5-19 Tools required to fasten the pressure relief vent to the roof
Procedure
1. Orientate the pressure relief vents with the baffle blades (arrows) pointing to
the center of the drive.
NOTE – The orientation of the baffle blades can be seen through the grille on
the underside.
Figure 5-20 Installation example of pressure relief vents
2. Fasten the pressure relief vent to the roof with the supplied
screws (Fig. 5-20).
1) Cordless drill
2) Torx bit
3) 24 x M6x20 Self-tapping (HAQN40105P0260)
1
2
3
1) Orientation of baffle blades
2) Center of drive
3) Pressure relief vents
1
1
2
3
3