ABB ACS6080 - Figure 8-4 Typical Full-Power (A) and Half-Power (B) Drive Modes; Operating Modes; Semi-Redundant Drive Control Panel

OPERATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
165/266
8.4.3.1. Operating modes
Several power operating modes (POMs) are possible in full-power drive mode and
in half-power drive mode. The selection of the POM and the control of the inverter
output disconnectors is done either by software or a hardware interface on the
drive (project specific).
For project specific instructions please consult the corresponding application
note.
Fig. 8-4 shows typical full- and half-power modes. For further variants, refer to the
Signal and Parameter Table document.
Figure 8-4 Typical full-power (A) and half-power (B) drive modes
8.4.3.2. Semi-redundant drive control panel
The semi-redundant drive control panel can be operated in both local and remote
mode. For more information, see the appropriate application note.
1) MCB 1
2) MCB 2
3) ARU1
4) INU1
5) CBU1 or BCU1
6) CBU2
7) INU2
8) ARU2
9) EXU
10) Output isolator 1
11) Output isolator 2
12) Motor
13) Synchronous motor
AB
1 12 2
3 34 45 56 67 78 8
9 9
10 1011 11
12 12
13 13