MECHANICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
92/266
5. After adjusting a pipe joint, alternately tighten the bolts lightly.
6. Tighten the bolts to the torque indicated on the pipe joint.
5.6.1. Removing a pipe joint
1. Loosen the bolts alternately but do not remove them completely.
2. Slide the pipe joint to the side.
NOTE – The sealing lip can touch the pipe end.
3. Turn and move the pipe joint smoothly.
4. Clean the pipe joint and treat the bolts with an appropriate lubricant before
refitting.
To Next Page
Loading...
