TRANSPORTATION, STORAGE AND DISPOSAL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
82/266
4.6. Storage
The drive can be stored for up to one year in the original packaging as long as it is
not damaged or opened.
For information on longer storage periods, contact the ABB service organization.
4.6.1 Storage conditions
The minimum requirements for storage are based on IEC 60721-3-1.
4.6.2 Storing the drive
If the drive is taken out of service for a longer time proceed as follows:
1. Drain the cooling circuit completely or add the appropriate amount of glycol
for frost proofing if the drive is to be stored in ambient temperatures below
0 °C.
For information about draining and frost proofing, see the manual of the water
cooling unit in “Appendix A - Additional manuals”.
2. Cover all cable inlets and ventilation slots with an impermeable plastic or
aluminum foil and a wooden panel.
3. Add a desiccant of the appropriate quality:
• 1 unit desiccant (30 g) absorbs 6 g water vapor
IMPORTANT! If you use polyethylene foil to cover the cabinets, use 10 units of
desiccant/m
2
foil.
4. Close and lock the doors of the drive.
5. Use polyethylene or equivalent for packaging:
• 0.3 g/m
2
/24 h water vapor diffusion
6. Attach humidity indicators to the packaging.
NOTICE The storage conditions and the packaging should be checked
regularly. Any damages which occur during the storage period must be
repaired immediately.
4.6.3. Storing and handling of spare parts
– Classification: 1K22 / 1B1 / 1C2 / 1S11 / 1M11
(1)
(1)
Special conditions apply to marine drives
NOTICE Risk of component damage!
Electronic devices (eg, circuit boards, semiconductors) are sensitive to
electrostatic discharge (ESD).
– Apply ESD handling precautions before handling these devices.
To Next Page
Loading...
