MECHANICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
90/266
5.5. Joining transport units
This section applies to drives that are delivered in multiple transport units.
Procedure
1. Join the transport units at the connection points that are indicated in Fig. 5-1.
NOTE – Some of the connection points might not be accessible in certain
configurations. In such cases, you only need to join the connection points that
you can access.
Figure 5-1 Connection point locations on transport units
NOTICE Risk of component damage!
– DO NOT move joined transport units with a crane!
– Use transport means, such as heavy load hydraulics rollers or air
cushions instead.
1) Connection point locations 2) M6 x 16 (9ABA450093R0259
SCR-CBS-M6X16-8_8-FLZNNC)
2
To Next Page
Loading...
