ELECTRICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
131/266
6.6.3. EXU cable entry with EMC plate and sealing grommets
This section applies to drives that are delivered with an EXU.
1. Insert the power cables through the EMC plates into the cabinet.
NOTE – Depending on the cable entry configuration, the entry plate is either
on the top or on the bottom of the cabinet.
2. Cover the unused cable entry with a blanking plate.
Figure 6-16 EXU with top cable entry (A) and EXU with bottom cable entry (B)
If the cabinet is only accessible from the front and the cables are entered through
the bottom, proceed as follows:
1. Remove the front cover and, if present, unplug the heating cable and remove
the cross brace with the heating cable.
2. Remove the cover above the fan unit.
3. Remove the fan unit as explained in “10.4.17 Replacing the fan unit in an EXU
with a DCS800 D4 size controller” on page 258.
4. Unplug the fan power supply cables and the tube from the air pressure switch.
Figure 6-17 EXU cabinet
1) Top cable entry 2) Bottom cable entry
1) Front cover 2) Pull relief
1
2
2
To Next Page
Loading...
