ELECTRICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
139/266
6.8. Auxiliary power, control and serial
communication cables
The following sections describe how to prepare and route cables.
For a description on how to prepare the cable entries, see “6.6 Preparing cable
entry systems for TEU, ARU and EXU cabinets” on page 128.
See “Appendix C - Mechanical drawings” for information on:
– Project-specific cable entry
– Dimensions between point of cable entry and terminals
See “Appendix D - Wiring diagrams” for information on:
– Conventions for cross-references and device identification
– Terminal designations
6.8.1. Determining the cable length
1. Determine the required length of a cable between the point of entry and the
connection point inside the cabinet.
2. Cut the cable to the required length before connection.
To Next Page
Loading...
