POWER ELECTRONICS AND CABINET FEATURES
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
72/266
3.5. Cabinet design
The cabinet has been designed using the modular cabinet system of ABB and fulls
the requirements of international standards.
The design consists of a skeletal frame made of galvanized steel where the outer
panels made of 1.5 mm thick painted galvanized steel are bolted to. Corrosion
resistant materials are used to ensure durability of the cabinets.
Figure 3-30 Basic cabinet design
Electromagnetic compatibility (EMC)
Electromagnetic compatibility (EMC) has been achieved by applying an EMC
sealing around the doors and on the rear and side panels. The inside panels of the
compartments are not painted, because paint tends to reduce the effectiveness of
metallic bonding, which is paramount to successful EMC.
The joining surfaces of two transport units are equipped with EMC sealing strips.
The cabinet doors and the internal cable ducts are also equipped with EMC sealing.
Degree of protection
The standard cabinets are rated for IP 32. Ratings for IP 42 and IP 54 are available
as an option. The sound pressure level is < 75 dB (A).
Painting
The standard color for the cabinets is RAL 7035 (light gray), which is applied as a
powder coat paint. Other colors are available on request. For more information,
see the “Painting specification for ACS1000, ACS2000, ACS5000 and ACS6000/
ACS6080” (3BHS104301 E01).
1) Outer panel made with 1.5 mm powder
painted (standard color - RAL 7035)
galvanized steel
2) Galvanized steel frame
To Next Page
Loading...
