TRANSPORTATION, STORAGE AND DISPOSAL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
83/266
4.6.3.1. Warranty information
IMPORTANT! Check the spare parts immediately after receipt for damages and
report any damage to the shipping company and the ABB service organization.
Observe the following to maintain spare parts in good condition and to keep the
warranty valid during the warranty period:
– Keep spare parts in their original packaging.
– Store printed circuit boards in antistatic bags or boxes.
– Storage temperature range: -5 °C to + 55 °C
– Storage place requirements:
• Free of vibration and shock
• Protected against dust, sand, vermin and insects
• Free of corrosive gases, salt or other impurities that could damage
electronic equipment
• Dry, no condensation
• Relative humidity: 5 – 85%
– DO NOT touch a circuit board without wearing a wrist grounding strap.
– Put the component on a grounded working surface protected against
electrostatic discharges.
– Hold the component only by the edge.
To Next Page
Loading...
