MECHANICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
88/266
5.4. Aligning transport units
This section applies to drives that are delivered in several transport units.
1. If a transport unit has water pipes, remove the protective covers from the
water pipe ends on both sides.
2. Check that a pipe joint (1) has been slid on one pipe end of two adjoining
water pipes.
3. Line-up the transport units as shown in “Appendix C - Mechanical drawings”.
NOTE – The units can be lined-up either beginning from the left or the right.
1
To Next Page
Loading...
