ABB ACS6080 - Figure 6-20 Preparing Cables for EMC Plates: (A) Cables with an Outer Screen or Shield, (B) Cables Without an Outer Screen or Shield or (C) Cables in an EXU Cabinet

ELECTRICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
135/266
3. Slide the grommet onto the cable and ensure that the grommet fits tightly to
prevent water from entering the cabinet.
NOTE – If cables are entered through the cabinet floor, the grommets can be
discarded.
4. If necessary, remove the entry plate and push the cable through the entry
holes.
5. Prepare standard cables according to Fig. 6-20.
6. Prepare EXU cables according to Fig. 6-20.
The orientation of the EMC plates in both scenarios is the same for top and
bottom cable entries, ie, the sealing grommets face upwards.
Figure 6-20 Preparing cables for EMC plates: (A) cables with an outer screen or
shield, (B) cables without an outer screen or shield or (C) cables in an EXU cabinet
1) Grommet
2) EMC sleeve
3) Cable tie
4) Heat-shrinkable termination
5) Outer cable sheath
6) Entry plate
7) Conductor insulation removed to expose
cable shield
8) Cable screen extension to connect to
the PE busbar
9) Cable clamp
ABC
1
1
2
2
3
4
5 5
6
6
7
7
8
9