ABB ACS6080 - Preparing cable entry systems for TEU, ARU and EXU cabinets

ELECTRICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
128/266
6.5.4. EMC plates with sealing grommets
Figure 6-13 Cable entry with EMC plates
6.6. Preparing cable entry systems for TEU, ARU and
EXU cabinets
This section describes how to prepare cable entry systems for the following
cabinets:
– TEU
– ARU
– EXU
6.6.1. TEU cable entry frames with type 1 sealing modules
– Use one sealing module (5) for each conductor of a three-core cable, or one
sealing module for the complete cable.
– In the openings facing the back wall of the TEU, place the compression wedge
(4) between the frame (1) and the sealing module (5).
This ensures that the minimum distance to the high-voltage busbars
is maintained.
1) EMC sleeves
2) Sealing grommets
3) ∅45 mm
4) 1.5 mm
Usage – Power cables
– Ground cables
– Bonding conductors
– Auxiliary power cables
– Control cables
Included in delivery – Galvanized plate with net-like EMC sleeves
– Sealing grommets
1
2
3
4