TRANSPORTATION, STORAGE AND DISPOSAL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
80/266
4.5.1.1. Lifting recommendations
Refer to Fig. 4-1 and Fig. 4-2 when following these ABB recommendations:
– Use a lift frame or a lift spreader with the crane.
– Use lifting equipment (eg, web slings, chain slings, round slings, safety hooks,
shackles) that corresponds to the weight that is to be lifted.
– Attach the slings to the lifting brackets at the base frame.
– To attach the slings, screw an eye bolt (not supplied) into each of the four
corners of the cabinet roof
– Use appropriate safety hooks or shackles to attach a sling.
– DO NOT pass a sling through the hole of the bracket.
– Protect the edges and the door handles if the slings are too close to the
cabinet.
– If a lift frame or lift spreader is not available, make sure that the slope angle is
a maximum of 15° (see Fig. 4-2).
– Observe the center of gravity
– Lift the drive or a transport unit slowly and steadily to the required clearance
height, maintaining it in upright position.
– Check the horizontal position and reposition the slings if necessary.
Figure 4-1 Lifting bracket on base frame of a drive, safety hook secured to lifting
bracket and eye bolt.
1) Lifting bracket (hole ∅42 mm)
2) Safety hook
3) Eye bolt
1
2
To Next Page
Loading...
