Appendix F - Remote Access
Acterna ANT-5 Page 153
6. Click on the X.25 tab to check the default settings, click on OK to finish.
7. If you are connecting to a BN4565/02 or BN4565/03, be sure there is no TZ
environment variable. Do the following:
• Select Start > Settings > Control Panel > System.
• Click the Environment tab.
• If an environment variable TZ appears, delete it.
• Exit the Control Panel.
8. If you are connecting to a BN4565/01, define a TZ environment variable. Do the
following:
• Select Start > Settings > Control Panel > System.
• Click the Environment tab.
• Click New. The New System Variable dialog box appears.
• Type TZ in the Variable Name field.
To Next Page
Loading...
