Appendix F - Remote Access
Acterna ANT-5 Page 161
15. If privileges allow select the Sharing tab, and emulate the following settings. Click
OK to close the ANT-5 Remote Operation Unit Properties dialog.
16. If you are connecting to a BN4565/02 or BN4565/03, be sure there is no TZ
environment variable. Do the following:
• Select Start > Settings > Control Panel > System.
• Click the Advanced tab.
• Click Environment Variables.
• If an environment variable TZ appears, delete it.
• Exit the Control Panel.
17. If you are connecting to a BN4565/01, define a TZ environment variable. Do the
following:
• Select Start > Settings > Control Panel > System.
• Click the Advanced tab.
• Click Environment Variables.
• Click New. The New System Variable dialog box appears.
To Next Page
Loading...
