Agilent Technologies 4288A User Manual

Appendix B 239
Information for Replacing 4278A with 4288A
At-a-Glance List of GPIB Command Correspondence
B. Information for Replacing
4278A with 4288A
DSTD= Sets the D value of the standard for the standard (LOAD) compensation. :CORR:CKIT:STAN3 on page 155
DTIM= Sets the delay time (trigger delay time). :TRIG:DEL on page 195
DVAL{1|2} Sets the display mode. :CALC1:MATH:EXPR:NAME on page 148
[ E ]
ERR? Reads out the error message number. :SYST:ERR? on page 192
[ F ]
FREQ{1|2} Sets the measurement frequency. :SOUR:FREQ on page 187
[ G ]
GSTD= Sets the G value of the standard for the standard (LOAD) compensation. :CORR:CKIT:STAN3 on page 155
[ H ]
HIAC{0|1} Turns ON/OFF the HI-ACC mode. N/A
[ I ]
ITIM{1-3} Sets the integration time (measurement time). :APER on page 130
[ L ]
LMOD{1-3} Sets the limit mode (limit range specification method). :CALC:COMP:MODE on page 141
LOAD Loads (recalls) the measurement condition. *RCL on page 126
LPAR{1-6} Sets the parameter to be sorted by the comparator. N/A (Dependent on the measurement
parameter and cannot be set up separately.)
[ M ]
MCOM{0|1} Turns ON/OFF multi-compensation. :CORR:MULT on page 161
MPAR{1-6} Sets the measurement parameter. :CALC1:FORM on page 147,
:CALC2:FORM on page 150
[ N ]
NOM= Sets the nominal value (reference value) in the tolerance mode. :CALC:COMP:PRIM:NOM on page 144
[ O ]
OFFA= Sets the offset compensation value for the primary parameter. :CORR:OFFS:DATA on page 164
OFFB= Sets the offset compensation value for the secondary parameter.
OPEN{0|1} Turns ON/OFF the OPEN compensation. :CORR:OPEN on page 165
OPM? Reads out the measured OPEN compensation value (data for OPEN
compensation).
:CORR:DATA on page 158
OSC= Sets the OSC level (measurement signal level). :SOUR:VOLT on page 188
[ R ]
RA{0-7} Sets the measurement range when the measurement frequency is 1 kHz. :RANG on page 184
:RANG:AUTO on page 185
RB{0-11} Sets the measurement range when the measurement frequency is 1 MHz.
RC= Sets the measurement range value for the HI-ACC mode. N/A
RCNT Resets the BIN count value. :CALC:COMP:COUN:CLE on page 137
REVP{0|1} Turns ON/OFF the reverse parameter function. N/A
[ S ]
Table B-25 At-a-glance list of GPIB command correspondence between 4278A and 4288A
(alphabetical order)
4278A Function overview 4288A

Agilent Technologies 4288A Specifications

General

Brand	Agilent Technologies
Model	4288A
Category	Measuring Instruments
Language	English