Alcatel-Lucent 7360 - Page 400

5 — VoIP overview
5-54 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
obsolete_hold Indicates whether the user agent
must use the obsolete hold
convention (a connection
address of 0.0.0.0) when placing
a media stream on hold. This is a
string containing a value of “yes”
or “no.” The default value is
“yes.”
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
session_timer_min The minimum acceptable value
for the RFC 4028 session timer
interval. This is a non-negative
integer. The value is expressed
in seconds. The default value is
90, which is the RFC 4028
absolute minimum.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, D,
H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
session_timer_max The RFC 4028 session timer
interval to be proposed by the
user agent. This is a
non-negative integer. The value
is expressed in seconds. The
default value is 1800, which is
the RFC 4028 recommended
value.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, D,
H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
session_timer_refres
her
Specifies the refresher to be
specified by the user agent when
it has a choice. A value of “none”
specifies that the user agent will
not request session expiration.
Any other value specifies that
the user agent will request
session expiration. This is a
string containing either “none,”
“uas,” or “uac.” The default
value is “uas.”
Some devices ignore the “none”
option. Contact your support
representative for more
information.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, D,
H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(12 of 30)