Alcatel-Lucent 7360 - Page 399

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-53
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
bridged_line_uri The bridged line agent URI if the
bridged line service is enabled. If
this property is not set, the user
agent does not enable the POTS
line to act as one of a set of
bridged lines.
YYPackage
A, B, H
only
Yes TL1 using
BRIDGEURIPR
OFID using
ent-profile-v
oipappservic
e
CLI using
b r id g e -p r of
using
configure
voice ont
voip-app-serv
ice
bridged_line_dialog
_uri
The bridged line dialog URI used
by the bridged line service. If
this property is not set, the user
agent uses the bridged_line_uri
setting as the bridged line dialog
URI.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
cfwd_state Indicates whether the state of
the network-based call
forwarding service is to be
rendered to the user.This is a
string containing a value of “yes”
or “no.” The default value is
“no.”
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, H,
I-240W-
S ONT
only
Yes TL1 using
CALLPRESENT
set to 8 using
ent-profile-v
oipappservic
e
CLI using
call-fwd-indi
cate
using
configure
voice ont
voip-app-serv
ice
cfwd_reminder Indicates whether a reminder
alert is to be provided to the user
when the network-based call
forwarding service redirects a
call. This is a string containing a
value of “yes” or “no.” The
default value is “no.”
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
cfwd_event_uri The URI to which a call
forwarding event subscription is
sent. If this property is not set,
but either cfwd_state or
cfwd_reminder is set to “yes,”
the call forwarding event
subscription is sent to the URI
specified in the
address_of_record property.
This value is a URI.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(11 of 30)