6 — ONT management using an ONT interface
6-32 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Table 6-8 ONT LEDs
This section shows you how to check the current and persistent state of LEDs.
Prerequisites
The prerequisites are:
• The user access level of the ONT is read-write.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-4 for CLI interface using the first Ethernet port.
Procedures using HTTP interface
The following procedure provides the steps to check the status of the ONT LEDs
using the HTTP interface.
LED Description
EQPT Battery power is available.
PON The PON is communicating with the ONT.
IPTV The IPTV service is provisioned.
RFTV The RF video is provisioned.
POTS A phone is off-hook.
MGMT Communication is established between the P-OLT and ONT through OMCI.
NTWK The 1490 nm data path is available.
DATA The data (Ethernet or MoCA) link is active, or if the data link is not active or
not provisioned.
VID The video signal is above or below acceptable level or not provisioned.
FAIL The equipment is 100% operational, or the equipment has failure, or is not
ranged or synchronized.
BTRY The status of the battery
MOCA The activity on the MoCA link
PWR_LED There is power to the ONT
ALM_LED The operational state of the ONT
WAN_LED The ONT is connected properly to the PON.
Note — Table 6-8 lists all possible LEDs on an ONT. For a list of
LEDs specific to a particular ONT, see the unit data sheet for that
ONT.
To Next Page
Loading...
