Configuring VLAN Stacking Verifying the VLAN Stacking Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 35-26
Verifying the VLAN Stacking Configuration
You can use CLI show commands to display the current configuration and statistics of service-based
VLAN Stacking on a switch. These commands include the following:
For more information about the resulting displays from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide. An example of the output for the show ethernet-service command is also
given in “Quick Steps for Configuring VLAN Stacking” on page 35-8.
ethernet-service transparent-
bridging
Displays the SVLAN configuration for the switch.
show ethernet-service Displays the VLAN Stacking service configuration for the switch.
show ethernet-service sap Displays the VLAN Stacking service access point (SAP)
configuration for the switch.
show ethernet-service nni Displays configuration information for NNI port parameters.
show ethernet-service uni Displays profile associations for UNI ports.
show ethernet-service uni-profile Displays UNI profile attribute values.
show ethernet-service sap-profile Displays SAP profile attribute values.
To Next Page
Loading...
