Diagnosing Switch Problems Port Monitoring
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 34-19
Configuring a Port Monitoring Session
To configure a port monitoring session, use the port-monitoring source command by entering port -
monitoring, followed by the user-specified session ID number, source, the slot number of the port to be
monitored, a slash (/), and the port number of the port.
For example, to configure port monitoring session 6 on port 2/3 enter:
-> port-monitoring 6 source 2/3
In addition, you can also specify optional parameters shown in the table below. These parameters must be
entered after the slot and port number.
For example, to configure port monitoring session 6 on port 2/3 and administratively enable it, enter:
-> port-monitoring 6 source 2/3 enable
These keywords can be used when creating the port monitoring session or afterwards. See the sections
below for more information on using these keywords.
Enabling a Port Monitoring Session
To disable a port monitoring session, use the port-monitoring source command by entering port -
monitoring, followed by the user-specified session ID number, source, the slot number of the port to be
monitored, a slash (/), the port number of the port, and enable. For example, to enable port monitoring
session 6 on port 2/3, enter:
-> port-monitoring 6 source 2/3 enable
Disabling a Port Monitoring Session
To disable a port monitoring session, use the port-monitoring command by entering port-monitoring,
followed by the port monitoring session ID and pause. For example, to disable port monitoring session 6,
enter:
-> port-monitoring 6 disable
Deleting a Port Monitoring Session
To delete a port monitoring session, use the no form of the port-monitoring command by entering no
port-monitoring, followed by the port monitoring session ID. For example, to delete port monitoring
session 6, enter:
-> no port-monitoring 6
Note. One port monitoring session can be configured per chassis.
keywords
file
no overwrite
bidirectional
disable
brief
no file
inport
timeout
capture-type
size
outport
enable
full
To Next Page
Loading...
